Zen time piece
The fountain has two inputs, one land and 4 outputs The 12v to 10-amp source and cables will be used for the electrical connection The display adapter connects to the board in the pin area, it is very easy to connect it, but you must be careful with the pins so as not to bend them ( picture 5)Īll connections must be made without power, it is dangerous to make connections while the source is connected to the power supply. The limits switches must be connected on the board, in this step it is important to check which pins are being connected since if they connect making "short" the Arduino will burn Pins marked X-min and Y-min should be used ( Picture 4 )įinally you have to connect the LCD screen to the ramps1.4 board, this is important since this screen has support for SD card and will allow the table to work without being connected to a computer, the display has two numbered connectors, you only have to respect that the 1 connects with the 1 and the 2 with the 2. The motors must be connected next to their controller, the orientation of the motor is not important only changes the direction of rotation, but the 3 motors must be connected in the same sequence of colors as seen in the last image.
#Zen time piece driver#
When connecting the driver in your space it is important to check the orientation since if you connect upside down the driver is burned, in the following image you can see that the heatsink must be on the right side and the regulator screw on the left side.
#Zen time piece drivers#
The 1.4 ramp shield should be placed on top of the Arduino mega making sure all pins enter properlyįor this project only 3 motors will be used, so 3 drv8825 drivers must be connected, placed in the spaces of "Motor X", "Y Engine" and "Extruder 1"īefore placing the drivers, jumpers must be placed to enable micro stepping for each engine ( picture 2) The band must do the travel as line red line in the photo
The band must be passed around the engine pulley.The engine assembly is placed on the other side of the profile.The pulley nut should be loosened as much as possible without removing it from the screw, this is done to give more space to the belt.The pulley assembly is placed in the profile until it meets the limit.The side of the belt that is closest to the cart must be attached, the teeth of the band should see inwards of the profile and the band is stored inside the profile.The band must be passed through the pulley.